Cooling control

Factor specifies that only a certain proportion of the calculated cooling output is available within the attached time definition, determined by multiplying the calculated value by Factor.

Set Point specifies the set point for the room thermostat if cooling is needed.

Design Temp specifies the outdoor temperature at which the cooling radiator achieves its maximum output, Max Power.

Min Power specifies the minimum power available at the temperature Te Min within the time definitions when the cooling radiator is active. Please note that the radiator is assumed to have a thermostatically controlled valve that controls the cooling power actually supplied on the basis of current requirements.

Te Min specifies the outdoor temperature at which the available cooling output achieves its minimum. The available cooling power is controlled linearly between Te Min and Design Temp, while outside this interval it is Min Power and Max Power respectively. The output is 0 outside the set time definitions.

Sensor Zone tells the program in which zone the sensor for controlling the cooling system is located. Selecting (None) is the same as selecting the zone itself, and the system can thus be coiped/moved from one zone to another without changes.